But i'm just not sure what to set my at4033 at There's a low cut and a pad selection on the mic The low pad has a straight line for one choice and a straight line that dips down as the second choice I had little to no trouble assembling the pieces and working out the first kinks By august i had successfully recorded an ep Has anyone experienced latency problems while using a usb condensor mic with sonar x1
I'm talking about delay when recording Like for example, you record your voice to the project's tempo, but the actual recordings have a slight delay and dont match up with the rest of the clips in the project (th. I was told by guitar center that the sterling audio st66 condenser mic is equivalent to the groove tubes gt66 and that the mics are made by the same mfr (aspen pittman). Previously i had set on the low cut switch for voice and guitar recording with good result How about piano recording (indoor, no fan or aircond blowing directly) While i don't normally do so, sometimes when i'm using the mic, i just leave it connected for days in between recording
It's one of the behringer large diaphragm condenser mic Hey cakewalkers, i'm considering buying a marshall as100d and playing through condenser mics for both vocal and instrument Trouble is that the amp's phantom power supply only puts in 15v. I can't get any signal through my id22 from an audio technica at4033se connected to either of the two xlr mic inputs Flicking the phantom power switch on or off makes the meters move momentarily, but otherwise i get not even a faint signal from the mic even with the input level turned up full I have a portable tascam dp 24 recorder, with 8 inputs at once, and would like to record a demo band in a practice studio and later mix it with sonar
3 mic for drums (one kick, 2 overheads), direct to tascam dp.1 mic for guitar amp, direct to tascam dp.1 di for bass guitar (x.
OPEN
