Over 30 years ago i did a little drag racing There was calculation we used for how much pipe was needed after the headers to get correct backpressure After that the pipe does nothing but move exhaust away from passengerrs Not much point to this story except to confirm that all the magic happens within a few feet of the heads. What size is the exhaust where it meets the muffler If someone were to do a muffler swap would a 2.5 inch diameter be the size
I will use the same muffler but dual exhausts instead of one and 2” piping instead of 2.5” Will it sound dramatically different the single exhaust with the the super 40 muffler vs same muffler with duals Thanks blue2010, dec 22, 2017 #7 Typically you would simply weld in a muffler at an exhaust shop with lower production models like the i4 2.7 The 2.7 hasnt changed since 2005 much so you can visit youtube and search for tacomas with 2.7 i4's and you'll find many likely have magnaflow etc welded in at a shop. The 40 series delta flow muffler cranks out an aggressive tone that’s slightly louder than pro series mufflers and features the same, low interior resonance
Hi everyone, i did a search without success. I was trying to find recommendations on a quiet aftermarket muffler or exhaust system, that that lets the. What do i need to connect a muffler with a 3 outlet to a 2.5 pipe I bought a flowmaster super 44 3 inlet and 3 outlet, but noticed that my pipes. Aside from a smaller diameter muffler/ silencer & chrome tip on the trd exhaust, they look identical Both have mandrel bends and follow the same routing
The stock has good back pressure and sounds fine so i am just going to leave as is and install the black tip to match the black accents on my trd sport.
OPEN
