Cartridge and chamber designs standardized by saami note Current cartridge & chamber drawing doc uments are contained within the saami standards They can be found here Information on how a cartridge becomes a saami standard can be found in our informational publications Newly accepted cartridge and chamber designs links to technical data and drawings for the newly saami accepted cartridge. Dimensional information for cartridges and firearm chambers, along with performance characteristics, is contained within the american national standards published by saami, listed below
As these standards are only periodically updated, drawings for cartridges and chambers introduced and standardized by saami or revised since the publication of the most recent standard can be found here Maximum average pressure levels greater than 65,000 psi may present increased risk of unsafe cartridge case or firearm rupture and thus require cartridge case and/or firearm designs that depart from traditional practices (materials, construction, and other design criteria). 25 creedmoor (25 cm) maximum average pressure (map)* = 62,000 psi The glossary of industry terms has been compiled by saami’s technical committee to facilitate technical interchanges between members of that committee It is not intended to provide legal definitions of the terms included, and, in light of further experience, the definitions of these terms may change It is not intended to be comprehensive since it does not cover the full range of the.
Saami was founded in 1926 at the request of the federal government and tasked with Creating and publishing industry standards for safety, interchangeability, and reliability The muzzle thread and socket drawings below are posted in accordance with saami’s mission to promote safety, interchangeability, reliability and quality and are available to the public, without restriction These drawings are not an approved american national standard (ans) at present Any questions about the drawings should be directed to saami staff The primary work of saami is done by its technical committee in the establishment of industry standards
Product standards for firearms and ammunition are developed by two product standards task forces, one for ammunition and one for firearms Recommendations of the task forces are submitted for review by the entire technical committee Saami announces acceptance of new cartridges shelton, conn — the sporting arms and ammunition manufacturers’ institute ®, inc., (saami ®) has announced the acceptance of three new rifle cartridges for saami standardization Saami is the organization at the forefront of promoting firearm safety by creating standards that ensure safety, reliability and interchangeability of firearms.
OPEN
