Hey guys, im just putting toghther my bottom end finally today and i plastigauged the main bearings, they are 0.001 at most I went ahead and lubed the bearings with the arp lube that came for the studs and then followed the arp torque procedure from jgs to torque them all down I currently have a ka24det with a felpro headgasket on a sr20det t25 running 10psi of boost I'm about to build another ka24det and was wondering how much boost/power is the felpro paper type headgasket good for (apparently i heard 400) I know people always bash on felpros and i was planning to run a multiple layer steel type cometic hg, but i also hear bad stuff about them New kat dyno z31 turbo 8psi by atomgrimus » sun feb 08, 2015 5:41 am im like 2 years late here lol, i got a t3 z31 turbo, i did research and it says on other forums that this turbo can only hold up to 6psi idk how true that is.
The operation of the swirl control valve extends the torque curve of the engine It does this by essentially providing two seperate intake velocities and torque curves that are switched, overlaying the curves as a single extended profile The scv are operated by a proprietary load and rpm based switching algorithm The ka24e ecu uses seperate maps for each state of the scv (open or closed. By ppctx » fri jun 06, 2008 12:02 am come on gentlemen, this is a kat forum.somebody has to have a little expertise with this topic. Ka intake manifold mysteries revealed
Ka24de oil pan with baffle’s, larger volume, return bung, temp bung…. So moroso has expressed interest to a local shop here to explore the market interest for this product Its pre design stages so comments are welcome Please post if u are interested or even if u think it’s a good idea Potentially this thread will be ammo to get moroso to take the plunge Who knows, it could be the.
Ok so i am going to post on here my wins and fails as i try to make it too 1,000hp I want to talk about my ideas for the car and my set up as well as bounce off ideas and get feed back Since i had that one i knew i wanted to build a turbo kat I have had a dream since i saw the 1,000hp evo 8 way back when that i.
OPEN
