This may be due to a browser extension, network issues, or browser settings Please check your connection, disable any. Swing the clamp down so that the jaw is under the edge of the bed flange extender Push the clamp handle toward the bed wall to lock it in place Repeat on the opposite side of the bed Attach the bracket on the end of the tether strap (m) to the slide block (j) with a lock washer (k) and the knob (l)
Repeat these steps on both sides of the bed You are ready to drive with your cover in the closed position The cover is easy to remove, and is mounted flush with your trucks bed rails. Any modi cations must be made to the bedliner and not the undercover mounting hardware Modi cations to the mounting hardware could result in improper installation and will void your warranty. Install bulkhead seal (d) included with cover (a) by cleaning the top of the bulkhead with soap and water to remove dirt and debris.
OPEN
