I intended to take a bunch of pictures and make sure i document my experience installing the sniper on my scrambler I probably did not get enough pictures or take enough botes, but here goes To start off, i replaced a holley 4bbl carb mounted on an offenhauser intake Is it more carb than. Just bought a 1983 scrambler and doing some restoration to it I want to get 35's on it but need to add a lift kit
I have been told that skyjacker has the best ride but also should look at old man emu Need some experienced scramblers with some advice on these lift kits with the softest ride. Well you know on a stock cj how the oil from the rear port/hole in the valve cover gets sucked up into the air cleaner & the filter gets full of oil after a. Ok, last week had a rough night and ended up blowing the fusible link that comes off the solenoid Went back the next morning and fixed that, and when jeep fired up i noticed my fuel lines were cracked coming off the filter (stock 1 inlet, 2 outlet) Scan of provided installation instructions
My lower steering shaft column bearing went out and i need to replace it Has anyone done this repair yet and how hard is it What do i need to look forward. Toying with the idea of keeping the scrambler (wife has already agreed) but this will definitely require performing an engine swap to make it long distance at 65 mph and partly to satisfy my need to tinker :d was considering dropping in a 4.0 fuel injection engine with an automatic. In front of walton lake (no relation as far as i know bw!) on a propane run
Absolutely beautiful october weather here in the hudson valley.
OPEN
