Kimber Lee Naked Classypornstars

Has anyone seen any kds9c rail specific holsters

I am having a hard time finding any options other than the couple that kimber offers Would a standard 1911 rail holster probably work Maybe a edc x9 rail holster I am looking for an iwb. My third kimber revolver, purchased and registered in late july '24, is at a local gunsmith shop after the diagnosis Broken firing pin and spring

The 2 da snubbie quickly became my favorite for cc My range log shows over 50 cylinders (about 300 rounds) fired as i tried as many kinds of. Kimber would be far better advised to delete barrel fluting, and focus on accuracy areas Barrel hood length and width fit to slide, bottom lug fit to slide stop, and muzzle area fit of barrel to slide Slide to frame fit is okay, but not great Chamber throat areas should be considered as well

Most 9mm's benefit from a throating reamer.

Kimber cs is correct, the number of problems is exceptionally low It’s just that visibility is very high due to ease of access Regardless of the product, there’s an overwhelming high number of people whose first post is to complain Can anyone recommend a good sight removal tool for a kimber 1911 From what little information i’ve found it seems kimber sights are very tight and difficult to remove I’m also unsure as to whether they remove left to right toward ejection port side or the other way

I've got 3 kimber ultra carry ii's that i've had for about 8 years They functioned well, the occasional (rare) malfunction, but not enough to cause me too much concern My wife became interested in shooting (girls with guns) and so i bought her two kimber ultra carry's on the same day One is the amethyst, the other is sapphire. From the various posts of purchases of the 2k11 over the last several months i'm curious What issues have those new owners experienced

Some others have reported light primer strikes, and fft

There was concerns about the ejector but i haven't read of those issues Thank you for your response. I contacted kimber today asking about the springs, i was wondering if i should install a heaver spring than the stock 18.5 lb, and questions about frame bashing using hot loads, i have a 10mm kimber eclipse, they said the gun can handle +p ammo, but do not use +p+, my question was that i reload using longshot and bludot powder, i usually load. Hey all, new to kimber, always been a fan I recently purchased two kds 9mm's, and a cds 9mm For the range i typically use winchester nato 124 gr ammo

All three guns are constantly jamming