Currently considering doing a simple axle dump exhaust setup on my 2020 v6 tacoma — basically chopping the tailpipe after the muffler and fabricating. New product and yes they are in stock and ready to ship Get rid of that unsightly tailpipe and resonator on your 2024 and up tacoma Typically you would simply weld in a muffler at an exhaust shop with lower production models like the i4 2.7 The 2.7 hasnt changed since 2005 much so you can visit youtube and search for tacomas with 2.7 i4's and you'll find many likely have magnaflow etc welded in at a shop. Over 30 years ago i did a little drag racing
There was calculation we used for how much pipe was needed after the headers to get correct backpressure After that the pipe does nothing but move exhaust away from passengerrs Not much point to this story except to confirm that all the magic happens within a few feet of the heads. I will use the same muffler but dual exhausts instead of one and 2” piping instead of 2.5” Will it sound dramatically different the single exhaust with the the super 40 muffler vs same muffler with duals Thanks blue2010, dec 22, 2017 #7
If someone were to do a muffler swap would a 2.5 inch diameter be the size Discussion in ' 1st gen So my muffler is going on my 2010 tacoma trd.anyone try an after market one Hi all, i've recently had a large (fist sized) hole blown out in the rear of the muffler from rust When looking online at replacement exhaust parts,.
OPEN
